Franke Consumer Products FTU 3807 I 사용자 설명서

Activated charcoal filter (Recirculation version)

• The filter is not washable and cannot be regenerated. It must be replaced when led S1

flashes or at least every 4 months. The alarm signal will only light up when the extractor
motor is switched on.

Alarm signal activation
• In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or

at a later date. Turn the Lights and the suction Motor off.

• Disconnect the Hood using the Main switch or the double-pole switch on the mains power

supply.

•  Restore the connection by pressing and holding T1.
•  Release the button.  All five LEDs are turned on
•  Within 3 seconds press T1 until LEDs  T1 and T4 flash in confirmation:
  LED flashes twice - Activated charcoal filter saturation alarm ENABLED
  LED flashes once - Activated charcoal filter saturation alarm DISABLED

REPLACING

Alarm signal reset
• Turn the Lights and the suction Motor off.
• Press T3 for at least 4 seconds, until indicators T1 and T4 flash

to confirm.

Replacing the Filter
• Open the lighting unit by pulling on the nocth

• Remove the metal grease filters

• Remove the saturated activated carbon filter by releasing the

fixing hooks

• Fit the new filter by hooking it into its seating
• Replace the metal grease filters and the lighting unit.

Lighting

LIGHT REPLACEMENT

20 W halogen light.
• Extract the lamp from the lamp holder by pulling gently.
• Replace with another of the same type, making sure that the

two pins are properly inserted in the lamp holder socket holes.