Bunn FMD-5 사용자 설명서

31

FIG. 20 EMI FILTER

Location:
 

The EMI Filter is located on the rear of the dispenser 

base on FMD DBC-3.

Test Procedure:

1.  Disconnect the dispenser from the power source.

2.  Disconnect the two black wires and two white 

wires on the EMI Filter from the EMI Filter wiring 

harness.

3.  Check for resistance between the two black leads 

on the EMI Filter.

If resistance is present as described the EMI Filter is 

operating properly.

If resistance is not present as described, replace the 

EMI Filter.

Removal and Replacement:

1.  Disconnect the wires from the EMI Filter.

2.  Remove the two #8-32 screws and nuts securing 

the EMI Filter.

3.  Remove and discard EMI Filter.

4.  Install new EMI Filter using two #8-32 screws and 

nuts to secure EMI Filter to its former location.

5.  Refer to schematic wiring diagrams when recon-

necting the wires.

FIG. 21 EMI FILTER CONNECTORS

118.0 kΩ - 118.5 kΩ

Across either pair

42672 122209