Cisco Systems DOC-7812945= 사용자 설명서

A-9

Cisco WAN Manager User’s Guide

Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003

Appendix A Internet Connectivity

PNNI Link

Step 5

Manually configure mapping for MGX 8850 Release 2:

map-list atm

ip 172.29.24.190 atm-nsap 47.0091.8100.0000.1010.1010.1010.1010.1010.1010.10

Step 6

Manually set up IP route table entries for MGX 8850 Release 2:

ip route 172.29.24.190 255.255.255.0 172.29.23.118

Step 7

Make sure IP routing enabled:

ip routing

PNNI Link

You must create a PNNI link between the MGX 8850 Release 2 node (for the node which is physically
connected to the router) and the router. To create a PNNI link, complete the following described below:

From the AXSM

Step 1

Create a UNI port,

popeye10.6.AXSM.a > addport 1 1.1 48000 48000 6 1

Step 2

Create a partition,

popeye10.6.AXSM.a > addpart 1 1 2 1000000 1000000 1000000 1000000 1 255 33 65535 100 1000

From the PXM

Step 1

Display the PNNI ports,

popeye10.7.PXM45.a > dsppnports

Step 2

Check whether the port is up and normal

PortId IF status Admin status ILMI state Total Activeconns

7.35 up up Undefined 0

7.36 up up Undefined 0

7.37 up up Undefined 0

7.38 up up Undefined 0

6:1.1:1 up up UpAndNormal 1

Step 3

If the port is displayed, then do the following:

popeye10.7.PXM45.a > dnpnport 6:1.1:1

popeye10.7.PXM45.a > cnfpnportsig 6:1.1:1 -univer uni31

popeye10.7.PXM45.a > uppnport 6:1.1:1

popeye10.7.PXM45.a >

addaddr 6:1.1:1 47.0091.8100.0000.1010.1010.1010.1010.1010.1010.10 160