Siemens SL8A5A7 사용자 설명서

다운로드
페이지 64
12
Operating the Dishwasher
Selecting the Proper Wash Cycle
Always make sure your dishware is dishwasher safe. Refer to the Dishware Materials section 
of this manual for guidance. 
ATTENTION
To avoid damage to delicate or heirloom items, do not wash them in your dishwasher.
Wash Cycles
Wash cycles accessible from this menu include:
Power
Cleans items having baked-on or hard dried-on food soils. These items may require soaking 
or hand scouring.
Auto
Takes the guesswork out of cycle selection. The sensors in the dishwasher automatically 
adjust the cycle length, temperature and water changes based on the soil load.
Basic
Cleans large loads with loosely attached food soils. 
Gentle
Cleans delicate or heirloom dishware and silverware, or other special items. Hand washing 
may be the best for such items.
Speed
Cleans lightly soiled dishes and reduces overall wash time. Use this cycle to clean glasses 
and desert dishes that may need to be re-used at the same event.
More information on dishwasher cycles is located in the Wash Cycle Information section of 
this manual.
Wash Cycle Options
PowerBoost Cycle Time Optimizer
Reduces the time to complete a wash cycle by preheating. To activate, select the Power-
Boost button in addition to the desired cycle.
Additional Drying Heat
With this option you can raise the temperature of the rinse water and increase the drying 
time which will result in improved drying.
To activate:
· Press and hold the left “Cancel Reset” button, then press and hold the On/Off button.
· When the LED display shows a “00” or a “01” release both buttons.
· To enable the Additional Drying Heat, press the left “Cancel Reset” button until the 
LED display shows a “01”.
· To disable the Additional Drying Heat, press the left “Cancel Reset” button until the 
LED display shows a “00”.
· Press the On/Off button to save the setting.
Delay Start
This option allows you to delay the start time of your dishwasher.
To activate:
· Turn the dishwasher on.
· Select the desired wash cycle.
· Press and hold the Delay Start button. Release when the desired delay time is shown 
in the display window.