Keurig B150 사용자 설명서

다운로드
페이지 9
 
 
2
B150 Direct Plumb Unit Installation Instructions 
 
The B150 brewer is designed to be easily transformed from the as-purchased, Pour Over 
configuration to a plumbed unit.  Reconfiguration is designed to be easily and quickly 
accomplished by a technician using only a #2 Phillips screw driver. 
  
It is advised that prior to beginning installation that all water be drained from the system 
using the drain tubes located at rear of brewer (see Page 8 for Draining Instructions).  The 
brewer MUST also be disconnected from AC power supply during DPK installation. 
 
1.  Disconnect the brewer from AC power and drain the brewer’s Hot Water Tank as 
detailed in instructions shown on Page 8. 
2.  Remove the Cold Water Tank (CWT) that came with brewer.  FIGURE 1 
3.  You will now need to remove two covers to properly connect the DPK to the 
B150 Brewer.  Turning the drained brewer on its left side, locate and remove the 
2 screws located below that Cold Water Tank.  For easy identification, the screws 
are located within indented surfaces on the Base Plate.   
FIGURE 2 
 
FIGURE 1 
 
 
       FIGURE 2 
4.  Remove and reserve the screws.  The Connection Access Plate can now be 
removed. FIGURES 3 & 4 
 
FIGURE 
    FIGURE