Bunn B10 사용자 매뉴얼

7

OFF

O

N

Insert a BUNN

®

 coffee fi lter into the brew funnel.

(Be sure to use BUNN

®

 coffee fi lters for proper brew-

ing. There is a difference.)
Order more paper fi lters direct from BUNN

®

 at:

www.bunn.com

Measure coffee into the fi lter and gently shake the 

fi lter to level the bed of grounds. To determine the 
amount of coffee to be used, see Page 8.

Make sure that the sprayhead is tight. Slide the brew 

funnel into the brewer under the warmer switch.   Place 
the lighted warmer switch in the “ON” position.

Raise the hinged fl ip-lid and pour a decanter of water 

into the top of the brewer. Place the decanter on the 
warmer, THEN close the lid. Your BUNN

® 

brewer will 

begin brewing coffee immediately. Flip-lid should also 
remain closed when brewer is not in operation.

P-206

P-205

P2241

P2247

P-215

When brewing has stopped, remove the brew funnel 

and  discard  the  fi lter  and  grounds.  Do  not  touch  hot 
grounds.

NOTE: Opening the lid during brew cycle will interrupt the fl ow of water into the tank, 
but will not interrupt the brewing process. The brewed coffee already in the funnel 
will empty into the decanter. When lid is closed, the fl ow of water into the funnel will 
resume until the brewing cycle is complete.
WARNING: Do not close the lid after pouring in water, without the decanter in place. 
Closing the lid releases the hot water.

The same basic steps can be used to obtain hot water by omitting the fi lter and coffee. 
The water from your BUNN

®

 coffee brewer is approximately 200° F.  This 

is hotter 

than the hot water from your faucet and must be handled with care.

Step 1

Step 2

Step 3

Step 4

Step 5