DeLonghi ECAM45.760 사용자 설명서
22
GENERAL ALARM
The inside of the appliance is very dirty.
Clean the inside of the appliance thoroughly,
as described in the section “Cleaning”.
If the message is still displayed after cleaning,
contact a Customer Experience.
as described in the section “Cleaning”.
If the message is still displayed after cleaning,
contact a Customer Experience.
EMPTY CIRCUIT, FILL CIRCUIT
Water delivery
PRESS OK
Water delivery
PRESS OK
The water circuit is empty
Ensure the water spout is inserted. Press OK
and deliver water from the spout (D5), until it
flows out normally.
and deliver water from the spout (D5), until it
flows out normally.
REPLACE FILTER
The water softener filter is exhausted.
Replace the filter or remove it as described in
the section “Water softener filter”.
the section “Water softener filter”.
SET DIAL TO CLEAN
Milk has been delivered recently and the tubes
inside the milk container must be cleaned.
inside the milk container must be cleaned.
Turn the froth adjustment dial to CLEAN.
INSERT WATER SPOUT
The hot water spout is not inserted or is
inserted incorrectly.
inserted incorrectly.
Insert the water spout (D5) as far as it will go.
INSERT MILK CONTAINER
The milk container is not inserted correctly.
Insert the milk container (fig. 23) as far as it
will go.
will go.
PROBLEM
POSSIBLE CAUSE
SOLUTION
The coffee is not hot
The cups were not preheated.
• Enable the cup warmer and let the cups
heat up for at least 20 min.
• Warm the cups by rinsing them with hot
water (Please note: you can use the hot
water function).
water function).
The infuser has cooled down because
2-3 minutes have elapsed since the last
coffee was made.
2-3 minutes have elapsed since the last
coffee was made.
Before making coffee, use the special function
to rinse and heat the infuser (page 10).
to rinse and heat the infuser (page 10).
A low coffee temperature is set.
Set a higher coffee temperature in the menu
(page11).
(page11).
The coffee is weak or does not have
sufficient ‘crema’
sufficient ‘crema’
The coffee is ground too coarsely.
Turn the grinding adjustment dial one click
anticlockwise towards “1” while the coffee mill
is in operation (fig. 14). Continue one click at
a time until coffee delivery is satisfactory. The
effect is only visible after delivering 2 coffees
(see the section: “Adjusting the coffee mill” on
page 12).
anticlockwise towards “1” while the coffee mill
is in operation (fig. 14). Continue one click at
a time until coffee delivery is satisfactory. The
effect is only visible after delivering 2 coffees
(see the section: “Adjusting the coffee mill” on
page 12).
The coffee is unsuitable.
Use pre-ground coffee for espresso machines.
The coffee is delivered too slowly or a
drop at a time.
drop at a time.
The coffee is ground too finely or has
gone stale.
gone stale.
Turn the grinding adjustment dial one click
clockwise towards “7” while the coffee mill is
in operation (fig. 14). Continue one click at a
time until coffee delivery is satisfactory. The
effect is only visible after delivering 2 coffees
(see the section: “Adjusting the coffee mill” on
page 12).
Always use fresh coffee. Try a different coffee.
clockwise towards “7” while the coffee mill is
in operation (fig. 14). Continue one click at a
time until coffee delivery is satisfactory. The
effect is only visible after delivering 2 coffees
(see the section: “Adjusting the coffee mill” on
page 12).
Always use fresh coffee. Try a different coffee.
TROUBLESHOOTING
Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Experience.