Stanley Black & Decker IP16 사용자 설명서

•  Make sure all couplers are wiped clean before con-

nection.

•  The hydraulic circuit control valve must be in the 

OFF position when coupling or uncoupling hydrau-

lic tools. Failure to do so may result in damage to 

the quick couplers and cause overheating of the hy-

draulic system.

•  Always store the tool in a clean dry space, safe from 

damage or pilferage.

•  Always replace hoses, couplings and other parts 

with replacement parts recommended by Stanley 

Hydraulic Tools. Supply hoses to the intensifier must 

have a minimum working pressure rating of 2500 

psi/172 bar. Supply hoses from the intensifier to the 

tool couplings and other high-pressure parts, must 

have a minimum working pressure rating of 10,000 

psi/700 bar.

•  All hoses must have an oil resistant inner surface 

and an abrasion resistant outer surface. Whenever 

near electrical conductors, use clean hoses labeled 

and certified non-conductive.

•  Never allow the working pressure of the intensifier 

or tool to exceed 10,000 psi/690 bar.

•  Always keep critical tool markings, such as warning 

stickers and tags legible.

In addition to the Safety Precautions found in 

this manual, observe the following for equipment 

protection and care.

•  Make sure that the compression tool, cutter, etc. to 

be operated is rated at 10,000 psi/690 bar. If other 

than 10,000 psi/700 bar, the intensifier relief valve 

must be adjusted to the pressure for the tool being 

operated.

•  Operate the intensifier within its rated capacity.
•  Do not use the intensifier for applications for which it 

was not designed.

•  Tool repair should be performed by experienced 

personnel only.

•  Never connect or disconnect couplers or port con-

nections with hydraulic pressure in the hose.

•  Always check high-pressure couplers for leaks and 

damage before operating the system at maximum 

rated pressure.

•  When the intensifier is not in use, attach thread pro-

tectors and install valve caps.