Sunrise Global CM250 IP 사용자 설명서
Chapter 4
PC-IP Operation
25
Serial Port - The default serial port is displayed. To change the
serial port setting, click on the box to select the available serial
ports that are displayed in a drop-down menu.
serial port setting, click on the box to select the available serial
ports that are displayed in a drop-down menu.
Rate - The rate may be set to 115,200 or 38,400. Be sure that the
selected rate matches the current setting of the Install Profiler.
Click on the box to select the desired communication rate from
a drop-down menu.
selected rate matches the current setting of the Install Profiler.
Click on the box to select the desired communication rate from
a drop-down menu.
USB to Serial Port Adapter - If your PC does not have an RS-
232 serial port, an adapter may be used to convert a USB port to
an RS-232 serial port. Use Belkin model F5U103. Other models
may not work properly. Most PDA adapters do not support a full
RS-232 implementation and will not work. For proper operation,
the Belkin adapter and software should be installed before your
PC-IP software. If necessary, un-install PC-IP and re-install
after the USB-to-serial port adapter software is installed.
232 serial port, an adapter may be used to convert a USB port to
an RS-232 serial port. Use Belkin model F5U103. Other models
may not work properly. Most PDA adapters do not support a full
RS-232 implementation and will not work. For proper operation,
the Belkin adapter and software should be installed before your
PC-IP software. If necessary, un-install PC-IP and re-install
after the USB-to-serial port adapter software is installed.
User Setup Access
In the User Setup Access area, the administrator can permit user
access to specific Setup screens, including: Channel Plan, Limits,
Cable Modem Setup, General Setup, Leakage, Upstream
Spectrum, Pilot Generator and RealView setups.
access to specific Setup screens, including: Channel Plan, Limits,
Cable Modem Setup, General Setup, Leakage, Upstream
Spectrum, Pilot Generator and RealView setups.
Auto Save Tests
The Install Profiler may be configured to automatically prompt
the user to enter a file name following each of the SMART tests.
The SMART tests include: Tap, Ground Block, Set Top and
Cable Modem. Selecting Enable the Test requires the user to
enter a file name following the test. Click on the current setting
to view the pull down menu and select the desired setting.
the user to enter a file name following each of the SMART tests.
The SMART tests include: Tap, Ground Block, Set Top and
Cable Modem. Selecting Enable the Test requires the user to
enter a file name following the test. Click on the current setting
to view the pull down menu and select the desired setting.
Detail Screen Access
The PC-IP user may control the access provided to the
Installer Profiler user. Many of the automated SMART tests
offer detailed measurement data screens, which can be
accessed by the user, if access is enabled. Each type of detail
screen is controlled individually. Enabling screens allows
access, while disabling screens prevents access. Click on the
current setting to view the pull down menu and select the
desired setting. Detailed screens include: Analog, Digital,
Cable Modem, Scan and Return Spectrum.
Installer Profiler user. Many of the automated SMART tests
offer detailed measurement data screens, which can be
accessed by the user, if access is enabled. Each type of detail
screen is controlled individually. Enabling screens allows
access, while disabling screens prevents access. Click on the
current setting to view the pull down menu and select the
desired setting. Detailed screens include: Analog, Digital,
Cable Modem, Scan and Return Spectrum.