ADIC 601354 사용자 설명서

4-14

Normal Operations

601354 Rev A

When a site requires the addition of another archive, the 
operations are almost identical to the operations outlined in the 
initial configuration section of this chapter. 

However, only certain archives may be configured. When 
VolServ software is installed, license strings are input that 
allow only specific archives to be configured. To add a new 
archive type, call ATAC to obtain a license string for that type 
of archive. 

•

In the USA and Canada, call 1-800-827-3822.

•

Outside the USA and Canada, call 303-874-0188 or toll-free 
00800-9999-3822.

•

support@adic.com

ATAC support personnel will request the host identifier or CPU 
identifier when a new license string is required. Use the cpuid 
or hostid commands to obtain the necessary identifier. 

Execute the mk_license utility to enter the license string using 
the following command line: 

$VS_DIR/utilities/mk_license 

Read the instructions provided on the terminal, exit the utility, 
and execute the command line using the proper arguments. Any 
additional steps are provided by ATAC. 

An audit command is used for two reasons. One is to input 
relatively large amounts of media into an archive at one time. 
Refer to 

to verify consistency between an actual archive’s contents and 
the VolServ database inventory. Refer to 

for more information about automated archive audits. Manual 
archive audits are detailed in 

.