Stoelting F112 사용자 설명서

17

The freezer has two lights that will alert the user if a problem occurs: an ADD MIX light and a Diagnostic Light.

The ADD MIX light will flash to alert the operator to a low mix condition. It does so by monitoring the mix level in the
hopper. When the ADD MIX light is flashing, refill hopper immediately.

The Diagnostic Light will flash if an error occurs. Refer to the chart below for details.

1. Power to freezer is off.
2. Blown fuse or tripped circuit.
3. Freeze-up (auger will not turn).

4. High pressure cut-out tripped.
5. Front door not in place.     

1. Supply power to freezer.
2. Replace or reset.
3. Turn CLEAN-OFF-ON switch to OFF (middle) 
position for 15 minutes, then restart.
4. Wait until automatic reset for freezer to start.
5. Assemble front door in place.

1. Drive belt failure.
2. Consistency temperature setting is too 
firm.
3. Refrigeration problem.

1. Replace drive belt.
2. Turn Consistency Adjustment knob counter-
clockwise.
3. Check system. (Call distributor for service)

1. Consistency temperature setting is too 
firm.                                                       

1. Turn Consistency Adjustment knob counter-
clockwise.

Defrost Mode

Torque is not 

met after 20 

minutes 

(22 minutes for 

shake)

Drive current is not sensed

Freezer left in clean 

mode for over 20 

minutes

N/A

N/A

The freezer attempts to sense drive 

current with a 3 second pre-stir.  If current 

is sensed, the freezer will return to normal 

operation.  If current is not sensed, the 

freezer will wait 7 minutes and try to 

sense current with another 3 second pre-

stir.  After the third attempt, the 

compressor will run on timers.

N/A

Every 7 minutes 

the auger will 

run for 90 
seconds.

Timers

Timers

Off

N/A

Contact Service 

Technician

Contact Service Technician

Turn CLEAN-OFF-ON 

switch to OFF 

(middle) position then 

turn the switch to ON.