Yamaha 006IPTO-F0 사용자 설명서
156
Chapter 13—Internal Effects
DM1000 Version 2—Owner’s Manual
Using Effects Processors via Aux Sends
You can use effects processors via Aux Sends by patching effects processor inputs to Aux
Outs, and effects processor outputs to Input Channels.
Outs, and effects processor outputs to Input Channels.
1 Recall an effect program you wish to use.
See page 177 for more information on recalling effect programs.
2 Press the DISPLAY ACCESS [INPUT PATCH] button repeatedly until the In
Patch | Effect page appears.
This page enables you to patch all inputs and outputs of Effects processors 1–4.
This page contains the following parameters:
A
IN
These parameter boxes select the signals to be fed to the effects processors.
These parameter boxes select the signals to be fed to the effects processors.
B
OUT
These parameter boxes select the destination of the signals output from the effects pro-
cessors.
These parameter boxes select the destination of the signals output from the effects pro-
cessors.
C
FOLLOW SURROUND
When surround effects (see page 161) are recalled to Effects processor 1, this button
sorts the effect inputs and outputs displayed in the list according to the order specified
on the Setup | Surr Bus page (see page 130). If the recalled surround effects are compat-
ible with 5.1 Channel systems, the surround bus setting for 5.1 surround mode will be
used.
When surround effects (see page 161) are recalled to Effects processor 1, this button
sorts the effect inputs and outputs displayed in the list according to the order specified
on the Setup | Surr Bus page (see page 130). If the recalled surround effects are compat-
ible with 5.1 Channel systems, the surround bus setting for 5.1 surround mode will be
used.
D
button
This button recalls the FX1 Edit–FX4 Edit pages, which enable you to adjust the effect
parameters.
parameters.
3 To select a signal to be input to the effects processor, move the cursor to
the desired In parameter box, rotate the Parameter wheel to select a signal
from the following options, then press [ENTER].
from the following options, then press [ENTER].
• – ..................................... No assignment
• AUX1–8 ......................... Aux Outs 1–8
• INS CH1–48 ................. Input Channel 1–48 Insert Out
• INS BUS1–8.................. Bus Out 1–8 Insert Out
• INS AUX1–8 ................. Aux Out 1–8 Insert Out
• INS ST-L & INS ST-R .. Stereo Out L & R Insert Out
1
2
3 4