Yamaha 006IPTO-F0 사용자 설명서
76
Chapter 6—Input Channels
DM1000 Version 2—Owner’s Manual
4 Use the EQUALIZER [Q], [FREQUENCY], and [GAIN] controls to adjust the Q,
frequency, and gain of the band selected in Step 3.
Pairing Input Channels
On the DM1000, you can pair adjacent odd-even Input Channels or counterpart channels
on Layer 1 and Layer 2 that share the same physical fader. Faders and most parameters of
paired channels are linked for stereo operation. Paired channels’ linked parameters and
non-linked parameters (that are available for independent control) are listed below:
on Layer 1 and Layer 2 that share the same physical fader. Faders and most parameters of
paired channels are linked for stereo operation. Paired channels’ linked parameters and
non-linked parameters (that are available for independent control) are listed below:
*
You can set this parameter for each channel independent-
ly if the GANG button is turned off on the
ly if the GANG button is turned off on the
/INS/DLY |
DLY page.
** You can set this parameter for each channel independent-
ly on the EQ | ATT page, but the paired channel settings
are linked on the EQ | Edit and View pages.
are linked on the EQ | Edit and View pages.
To pair channels, or to cancel channel pairs, you can use the [SEL] buttons on the top panel
or access the Pair/Group pages.
or access the Pair/Group pages.
Tip:
• Pressing and holding down the button selected in Step 3 resets the corresponding band gain.
• Pressing the SELECTED CHANNEL [HIGH] and [LOW] buttons simultaneously resets the
• Pressing and holding down the button selected in Step 3 resets the corresponding band gain.
• Pressing the SELECTED CHANNEL [HIGH] and [LOW] buttons simultaneously resets the
Q, frequency and gain for each band.
Linked parameters
[SEL] buttons
Faders
Channel on/off
Insert on/off
Solo on/off
Solo Safe
Aux on/off
Aux Send level
Aux Sends as Pre or Post
Gate
Comp settings
EQ settings
Fader group
Mute group
Fade time
Recall Safe
Non-linked parameters
Input patches
Insert patches
Output patches
Comp insert position
Phase
Delay on/off
Delay time*
Delay feedback
Delay mix
Routing
Pan, Follow Pan
Surround pan
Aux Send pan
Balance
Attenuators**