Hoshizaki MWH KM-515MAH 사용자 설명서

VI. Preparing the Appliance for Periods of Non-Use

NOTICE

• When storing the appliance for an extended time or in sub-freezing temperatures,

follow the instructions below to prevent damage.

• To prevent damage to the water pump, do not operate the appliance with the

control switch in the "WASH" position when the water tank is empty.

When the appliance is not used for two or three days under normal conditions, it is
sufficient to move the control switch to the "OFF" position. When storing the appliance for
an extended time or in sub-freezing temperatures, follow the instructions below.

1. Remove the water from the icemaker water line:

1) Turn off the power supply, then remove the front panel.
2) Close the icemaker water supply line shut-off valve and open the icemaker water supply

line drain valve.

3) Allow the line to drain by gravity.
4) Attach a compressed air or carbon dioxide supply to the icemaker water supply line

drain valve.

5) Make sure at least 3 min. have elapsed since you turned off the power supply. Make

sure the control switch is in the "ICE" position. Replace the front panel in its correct
position, then turn on the power supply.

6) Blow the icemaker water supply line out using the compressed air or carbon dioxide

supply.

7) Close the icemaker water supply line drain valve.

2. Remove the water from the water tank:

1) Turn off the power supply, then remove the front panel.
2) Move the control switch to the "OFF" position.
3) Remove the base cover, then disconnect one end of the pump tubing to drain the water

tank. See Fig. 6. After the water tank has drained, reconnect the pump tubing.

4) Replace the base cover and the front panel in their correct positions.
5) Remove all ice from the dispensing unit/ice storage bin. Clean the storage bin liner

using a neutral cleaner. Rinse thoroughly after cleaning.

Fig. 6

Disconnect This
End of Pump
Tubing to Drain
Water Tank

Base Cover