Tektronix AWG710B 사용자 설명서
Getting Started
1-10
AWG710&AWG710B Arbitrary Waveform Generator User Manual
Installation
Before installation, refer to the Safety Summary section at the front of this manual
for power source, grounding, and other safety information.
for power source, grounding, and other safety information.
Environment
Verify that you have the correct operating environment.
The AWG710&AWG710B Arbitrary Waveform Generator operates correctly in
ambient temperatures from +10
ambient temperatures from +10
°
C to +40
°
C and relative humidity from 20% to
80%. If the instrument is stored long time at temperatures outside this range, wait
for a while and then power on the instrument. For more operating environment
information, refer to Appendix A:Specifications on page A-1.
for a while and then power on the instrument. For more operating environment
information, refer to Appendix A:Specifications on page A-1.
Verify that there is nothing blocking the flow of air at the fan and air intake holes.
The instrument exhausts air with the fan on its left side. Leave space at the sides of
the instrument so that the instrument does not overheat. The following are the
minimum space requirements for air flow around the instrument:
The instrument exhausts air with the fan on its left side. Leave space at the sides of
the instrument so that the instrument does not overheat. The following are the
minimum space requirements for air flow around the instrument:
Rear
7.5 cm (3 in)
Right and Left
15.0 cm (6 in)
Top and Bottom
2 cm (0.8 in)
(The feet on the bottom of the instrument provide the required clearance when
set on a flat surface.)
set on a flat surface.)
CAUTION.
To prevent damage to the instrument, do not power on the instrument
at temperatures outside the specified temperature range.
NOTE.
If you are installing the instrument in a rack, refer to the instruction sheet
that comes with the rack–mounting kit for proper installation procedures.
NOTE.
If the air flow is restricted and the internal temperature of the
AWG710&AWG710B Arbitrary Waveform Generator exceeds the proper
operating range, the instrument displays a message “Out of temperature limit” and
temporarily shuts down to protect the internal modules from overheating. To
prevent temporary shutdown of the AWG710&AWG710B Arbitrary Waveform
Generator, do not restrict air flow through the chassis.
operating range, the instrument displays a message “Out of temperature limit” and
temporarily shuts down to protect the internal modules from overheating. To
prevent temporary shutdown of the AWG710&AWG710B Arbitrary Waveform
Generator, do not restrict air flow through the chassis.
If the AWG710&AWG710B
Arbitrary Waveform Generator
shuts down
unexpectedly, improve ventilation around the AWG710&AWG710B
Arbitrary
Waveform Generator
, and wait a few minutes to allow it to cool down; then
switch the power on again.
You cannot power on the instrument when the ambient temperature exceeds the
operation range. Wait until the instrument cools down, or the ambient temperature
decreases to valid operating temperatures, before turning on the instrument again.
operation range. Wait until the instrument cools down, or the ambient temperature
decreases to valid operating temperatures, before turning on the instrument again.