Vermont Casting DVA4136 전단
Ceramic Refractory
Installation Instructions
for use on Models:
33XDV, 36XDV, 39XDV,
DV360, DVA4136, DVB4136
33XDV, 36XDV, 39XDV,
DV360, DVA4136, DVB4136
Finish colors available: Sandstone, Colonial Red, Clas-
sic Black, Silver Gray. Country gray is available for the
DVA4136 and DVB4136 only.
Read these instructions before attempting to install
sic Black, Silver Gray. Country gray is available for the
DVA4136 and DVB4136 only.
Read these instructions before attempting to install
the panels.
CAUTION: Before starting installation of
the CR Kit allow unit to cool completely if
CAUTION: Before starting installation of
the CR Kit allow unit to cool completely if
it has been in operation.
Ceramic refractory panels are fragile until
held in place and supported. Handle with
Ceramic refractory panels are fragile until
held in place and supported. Handle with
care to avoid damaging or breaking.
Kit contents:
Kit contents:
•
Left Side Panel (1)
•
Right Side Panel (1)
•
Rear Panel (1)
•
Installation Instruction Sheet (not shown) (1)
Installation Instructions
Turn OFF gas and electrical supply to unit before
starting the CR kit installation.
1. Check all contents for damage or missing parts.
2. When the unit is cool, remove top louvre. (Refer to
starting the CR kit installation.
1. Check all contents for damage or missing parts.
2. When the unit is cool, remove top louvre. (Refer to
Homeowner’s Manual)
3. Open bottom louvre.
4. Remove the glass frame window. (Refer to Home-
4. Remove the glass frame window. (Refer to Home-
owner’s Manual)
5. Make sure logs are not hot and remove them. Logs
are fragile and easy to break. Handle with care.
6. Remove all the lava rock from the firebox floor.
Save for later.
7. Remove the deflector inside the firebox just behind
the glass. Save the screws.
8. Place the rear panel over the ledge of the rear
log support bracket. You may need to loosen the
screws securing the bracket. Re-tighten the screws
after placing the ceramic panel in place.
screws securing the bracket. Re-tighten the screws
after placing the ceramic panel in place.
9. Place one of the side panels into place. It will hold
the rear panel secure.
10. Place the other side panel into place.
11. Reinstall the deflector using the saved screws.
12. Re-install the lava rock. (Refer to Homeowner’s
11. Reinstall the deflector using the saved screws.
12. Re-install the lava rock. (Refer to Homeowner’s
Manual)
13. Reinstall the logs. (Refer to Homeowner’s Manual)
14. Reinstall the glass frame window and close the
14. Reinstall the glass frame window and close the
clamps.
15. Installation is complete.
16. Attach the top louvre (Refer to Homeowner’s
16. Attach the top louvre (Refer to Homeowner’s
Manual), turn ON the gas supply and electrical sup-
ply, light the unit and close the bottom louvre.
ply, light the unit and close the bottom louvre.
�����
����������������������
����
����������������������
����
Left Side Panel
Rear Panel
Right Side Panel
KT605
Fig. 1 Ceramic Refractory Kit contents.
10009406 6/07 Rev. 2
410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6
800-668-5323 • www.cfmcorp.com
CFM Corporation