Vermont Casting DVR28IN 사용자 설명서

3

This gas appliance must be installed by a qualified 
installer, preferably NFI or WETT (Canada) certified, 
in accordance with local building codes and with 
current CSA-B149.1 Installation codes for Gas Burning 
Appliances and Equipment. For USA Installations follow 
local codes and/or the current National Fuel Gas Code. 
ANSI Z223.1/NFPA 54.
In the Commonwealth of Massachusetts, all gas 
fitting and installation of this heater shall only be 
done by a licensed gas fitter or licensed plumber.
FOR SAFE INSTALLATION AND OPERATION PLEASE 
NOTE THE FOLLOWING:
1.  This fireplace gives off high temperatures and should 

be located out of high traffic areas and away from 
furniture and draperies.

2.  Children and adults should be alerted to the hazards 

of high surface temperatures of this fireplace and 
should stay away to avoid burns or ignition of clothing.

3.  CAUTION: Due to high glass surface temperature 

4.  Under no circumstances should this fireplace be modi-

fied. Parts removed for servicing should be replaced 
prior to operating this fireplace again.

5.  A professional service person should be contacted to 

inspect this fireplace annually. Make it a practice to 
have all of your gas fireplaces checked annually. More 
frequent cleaning may be required due to excess lint 
and dust from carpeting, bedding material, etc.

6.  Control compartments, burners and air passages in 

this fireplace should be kept clean and free of dust 
and lint. Make sure the gas valve and pilot light are 
turned off before you attempt to clean this fireplace.

7.  The venting system (chimney) of this fireplace should 

be checked at least once a year and if needed your 
venting system should be cleaned.

8.  Keep the area around your fireplace clear of combusti-

ble materials, gasoline and other flammable vapor and 
liquids. This fireplace should not be used as a drying 
rack for clothing, nor should Christmas stockings or 
decorations be hung on or around the fireplace.

9.  Under no circumstances should any solid fuels (wood, 

coal, paper or cardboard etc.) be used in this fire-
place.

10. The flow of combustion and ventilation air must not be 

obstructed in any way.

11. When fireplace is installed directly on carpeting, vinyl 

tile or any combustible material other than wood, the 
fireplace must be installed on a metal or wood panel 
extending the full width and depth of the fireplace.

12. This fireplace requires adequate ventilation and 

combustion air to operate properly. 

Remove any plastic from trim parts before turning the 
fireplace ON.
It is normal for fireplaces fabricated of steel to give off 
some expansion and/or contraction noises during the 
start up or cool down cycle. Similar noises are found 
with your furnace heat exchanger or car engine.
It is not unusual for your gas fireplace to give off some 
odor the first time it is burned. This is due to the curing of 
the paint and any undetected oil from the manufacturing 
process. 
Please  ensure  that  your  room  is  well  ventilated  - 
open all windows.
It is recommended that you burn your  fireplace for at 
least ten (10) hours the first time you use it. If the optional 
fan kit has been installed, place the fan switch in the 
“OFF” position during this time.

This appliance may be installed in an aftermarket per-
manently located, manufactured home or mobile home, 
where not prohibited by local codes.
This appliance is only for use with the type of gas indicat-
ed on the rating plate. This appliance is not convertible 
for use with other gases, unless a certified kit is used.

13. This fireplace must not be connected to a chimney 

flue serving a separate solid fuel burning fireplace.

14. When the fireplace is not in use it is recommended 

that the gas valve be left in the OFF position.

Proposition 65 Warning: Fuels used in gas, woodburning or 
oil fired appliances, and the products of combustion of such 
fuels, contain chemicals known to the State of California to 
cause cancer, birth defects and other reproductive harm.
California Health & Safety Code Sec. 25249.6