Vermont Casting DVR33 사용자 설명서

23

Vermont Castings, Majestic Products:  DVR33

10004920

• The use of any non-approved replacement glass

will void all product warranties.

• Care must be taken to avoid breakage of the glass.

• Under no circumstances should this appliance be

operated without the front glass in place, or with the
glass in a damaged condition.

• Replacement glass (complete with gasket) is

available through your Vermont Castings, Majestic
Products dealer, and should only be installed by a
licensed qualified service person.

To remove the louvre assembly top, lift the panel up
and out from the fireplace (Fig. 38).

It is necessary to periodically clean the glass panel.

During start-up, it is normal for condensation to form
on the inside of the panel. This condensation causes
lint, dust and other airborne particles to cling to the
surface of the glass.

Also, initial paint curing may deposit a slight film on the
glass. It is therefore recommended the glass panel be
cleaned two or three times with a non-ammonia-based
household cleaner and warm water within the first few
weeks of operation. We recommend using gas
fireplace glass cleaner.

After the initial cleaning process, clean the glass two or
three times during each operating season, depending
on the environment in the house.

Lower

Clamps

FP1191

Window
Frame
Assembly

Window Frame
Assembly

Fig. 39  Window frame assembly removal.

Pull Clamp Hook

Push Clamp
Handle

1. Turn the fireplace OFF (including the pilot).

2. If the unit has been operating, allow time for the

components to cool.

3. Remove the louvre assembly top.

4. Open the louvre assembly bottom.

5. Release the two clamps along lower edge of the

frame by pulling down on clamp handles (Fig. 39).

6. Tilt window frame assembly out slightly at the

bottom, lift the frame up and away from the
fireplace.

7. To replace window frame assembly, reverse this

procedure.

1.

2.

Louvre Assembly Top

Window Frame Assembly

FP444

Fig. 38  Remove louvre assembly top.