Vermont Casting BHDT36 사용자 설명서
- 25 -
GLASS FRAME REMOVAL
1.
Shut off gas.
2.
Let the fireplace cool if it has been operating.
3.
Remove top louvre. (See Louvre Removal)
4.
Open the lower louvre assembly.
5.
Release the two clamps at the bottom of the window
frame by pulling down on the clamp handles.
frame by pulling down on the clamp handles.
6.
Lift off the glass frame as shown.
7.
To reinstall glass follow the above procedure in
reverse. (Fig. 57)
reverse. (Fig. 57)
CLAMPS
FIREPLACE
FRONT
GLASS
FRAME
OPERATING INSTRUCTIONS
WINDOW
FRAME
FRAME
WINDOW
FRAME
FRAME
PULL
CLAMP HOOK
PUSH
CLAMP HANDLE
CLAMP HANDLE
(Fig. 56) To remove top louvre pull louvre up and then
lift out.
lift out.
GLASS
PANEL
PANEL
LOUVRE
1.
2.
GENERAL GLASS INFORMATION
Only glass approved for use in Majestic
products may be used for replacement.
products may be used for replacement.
1 . The use of subsitute glass will void all product warranties.
2.
2.
Care must be taken to avoid breakage of the glass.
3.
Under no circumstances should this appliance be
operated without the front glass or with a broken glass.
Replacement of the glass (with gasket) as supplied by
the manufacturer should be done by a licenced qualified
service person.
operated without the front glass or with a broken glass.
Replacement of the glass (with gasket) as supplied by
the manufacturer should be done by a licenced qualified
service person.
LOUVRE REMOVAL
Fig. 57
Fig. 56
GLASS CLEANING
It will be necessary to clean the glass periodically. During
start-up condensation, which is normal, forms on the inside
of the glass and causes lint, dust and other airborne
particles to cling to the glass surface. Also initial paint
curing may deposit a slight film on the glass. It is therefore
recommended that the glass be cleaned two or three times
with a non-ammonia household cleaner and warm water
(we recommend gas fireplace glass cleaner). After that the
glass should be cleaned two or three times during each
heating season depending on the circustances present.
start-up condensation, which is normal, forms on the inside
of the glass and causes lint, dust and other airborne
particles to cling to the glass surface. Also initial paint
curing may deposit a slight film on the glass. It is therefore
recommended that the glass be cleaned two or three times
with a non-ammonia household cleaner and warm water
(we recommend gas fireplace glass cleaner). After that the
glass should be cleaned two or three times during each
heating season depending on the circustances present.
Clean glass after first two weeks of operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.