Sony 2 사용자 설명서
209
Setup Relating to Operations From the Control Panel
Ch
apt
apt
er 16
E
ngin
eering Se
tup
3
To confirm the matrix source selection made in step
2
, press [Link Source
Set].
This confirms the selection, which is reflected in the status area.
4
As required, repeat steps
2
and
3
to select the matrix sources to be linked
to other cross-point buttons.
To initialize the set links
Press [Init Link Table].
A confirmation message appears.
Press [Yes].
The links set using the above procedure are initialized to the default settings,
and this is reflected in the status area.
Press [Init Link Table].
A confirmation message appears.
Press [Yes].
The links set using the above procedure are initialized to the default settings,
and this is reflected in the status area.
To make link bus settings
For the link number selected in the External Bus Link menu, use the following
procedure.
procedure.
1
In the Panel>Config>External Bus Link menu, press [Link Bus Adjust].
The Link>Link Bus Adjust menu appears. The status area lists the current
link status, and the switcher buses and routing switcher destinations that
can be selected.
In this menu too, you can use knob 1 to select the link to be set.
link status, and the switcher buses and routing switcher destinations that
can be selected.
In this menu too, you can use knob 1 to select the link to be set.
2
Using any of the following methods, select the switcher bus and the
routing switcher destination to be linked to the switcher bus.
routing switcher destination to be linked to the switcher bus.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the selection.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the selection.
3
To confirm the bus selected in step
2
, press [Master Bus Set], and to
confirm the destination press [Linked Dest Set].
This confirms the selection, which is reflected in the status area.
Linking transitions between keyers
Use the following procedure.
1
In the Panel>Config menu, press [Key Trans Link].
Knob
Parameter
Adjustment
Setting values
2
Internal Bus
Switcher bus selection
1 to 128
3
Destination
Routing switcher destination selection
1 to 128