Seagate ST3620N/ND/NC 사용자 설명서
![Seagate](https://files.manualsbrain.com/attachments/b8a65e13882738a617b4fb1dec35c49349976167/common/fit/150/50/2b4b03599a6f710d30699589ed58ececb8b6db2f0c51d2afc623a22705ee/brand_logo.png)
Hawk 1LP Family Installation Guide, Rev. D 31
continued from previous page
SSP*
Used only as a cable connection for the refer-
ence index signal (REFIND+) (J6 Pin 6, bot-
tom) for sync spindle feature. J6 pin 5 is GRD.
Install a jumper when no cable is attached.
Default is a jumper installed (not applicable to
"NC" models).
ence index signal (REFIND+) (J6 Pin 6, bot-
tom) for sync spindle feature. J6 pin 5 is GRD.
Install a jumper when no cable is attached.
Default is a jumper installed (not applicable to
"NC" models).
LED*
No jumper ever installed. These pins used to
connect a cable for a remote LED indicator. Pin
3 (top, nearest HDA), the anode connection,
connects in the drive to the +5V supply through
a pull-up resistor. Pin 4 (bottom), the cathode
connection connects in the drive to signal com-
mon through the emitter-collector junction of a
transistor switch that controls the LED on/off
condition.
connect a cable for a remote LED indicator. Pin
3 (top, nearest HDA), the anode connection,
connects in the drive to the +5V supply through
a pull-up resistor. Pin 4 (bottom), the cathode
connection connects in the drive to signal com-
mon through the emitter-collector junction of a
transistor switch that controls the LED on/off
condition.
RES
Reserved position. No jumper to be installed.
* See note [2] on page 27