Jenn-Air W10276070A 사용자 설명서

Your refrigerator has two adjustable, front leveling screws – one 
on each side of the refrigerator base. If your refrigerator seems 
unsteady or you want the door to close easier, use the instructions 
below. 
1. Remove the base grille. Grasp the grille firmly and pull it 

toward you.

2. Raise or lower the cabinet. 

Using a 

¹⁄₄" hex driver, turn the leveling screw on each side to 

raise or lower that side of the refrigerator.

NOTE: Having someone push against the top of the 
refrigerator takes some weight off the leveling screws. This 
makes it easier to turn the screws. It may take several turns of 
the leveling screw to adjust the tilt of the refrigerator.

■

To raise, turn the leveling screw clockwise.

■

To lower, turn the leveling screw counterclockwise. 

3. Open the door again to make sure that it closes as easily as 

you like. If not, tilt the refrigerator slightly more to the rear by 
turning both leveling screws clockwise. It may take several 
more turns, and you should turn both screws the same 
amount.

4. Replace the base grille.

There are two refrigerator compartment doors. The doors can be 
opened and closed either separately or together.
There is a vertically-hinged seal on the left refrigerator door.

■

When the left side door is opened, the hinged seal 
automatically folds inward so that it is out of the way.

■

When both doors are closed, the hinged seal automatically 
forms a seal between the two doors. 

The control center is located at the top front of the refrigerator 
compartment. 

For your convenience, your temperature controls are preset at the 
factory. When you first install your refrigerator, make sure the 
controls are still set to the recommended set points as shown.

■

The recommended settings should be correct for normal 
household refrigerator use. The controls are set correctly 
when milk or juice is as cold as you like and when ice cream is 
firm.

■

When the power is on, the temperature display shows the 
actual temperature of the compartment.

■

Wait 24 hours for your refrigerator to cool completely before 
adding food. If you add food before the refrigerator has cooled 
completely, your food may spoil.

NOTE: Adjusting the refrigerator and freezer temperature 
controls to a colder than recommended setting will not cool 
the compartments any faster.

■

If the temperature is too warm or too cold in the refrigerator or 
freezer, first check the air vents to be sure they are not 
blocked before adjusting the controls. 

A