Jenn-Air UNDER COUNTER REFREGERATOR 사용자 설명서

7

Hardwood

3

⁄

32

" (.23 cm)

Softwood

5

⁄

64

" (.20 cm)

23

3

⁄

4

"

(60.3 cm)

Custom panel

thickness: 

5

⁄

8

" to 

3

⁄

4

"

(1.6-1.9 cm)

30

5

⁄

16

"

(77 cm)

10 Pilot Hole

Locations

Inside of Door

1. Place the custom wood panel on a non-abrasive

surface, protected by towels or rugs, to avoid
accidental damage to the door finish.

2. Place the refrigerator door flush with the inside

surface of the custom wood panel.  Clamp the
wood panel to the door, if necessary.

3. Mark the hole locations with a pencil.

4. Drill the pilot holes into the custom panel.

5. Insert the wood screws through the back of the

door and into the pilot holes in the custom wood
panel and tighten.

6. Reinstall the door seal by pressing it into the door

channel, making certain the corners are fully
inserted.

7. Install the door back on the refrigerator using the

supplied plastic washers (as shown below).

8. Realigning the door may be necessary (see page 6).

Top Hinge Corner

Cabinet Hinge

Shoulder Bushing

Door Hinge

Washer

(Optional)

Bottom Hinge 

Corner

Cabinet Hinge

Shoulder Bushing

Door Hinge

Washer

•

Door can become disengaged if washers are not
installed.

•

Door may not swing properly if all nylon components
are not installed as shown.

1. #8 pan head wood screws are recommended to

properly secure the custom wood panel to the
refrigerator door.

2. A total of 10 screws are needed.

3. Use only pan head screws.

4. Be sure the screw length is NOT longer than the

wood thickness at the screw locations.

5. Use the following pilot hole drill sizes.

41007710 ENG 5/03  6/11/03  10:58 AM  Page 8