Jenn-Air W10735232A 사용자 설명서

1. Place an appliance dolly under the left side of the refrigerator 

as shown. Place the corner posts from the packing materials 
over the trims as appropriate. Slowly tighten the strap.

2. Place pieces of the shipping carton on the floor when rolling 

the dolly and refrigerator into the house. Move the refrigerator 
close to the built-in opening.

3. Place top of cardboard carton or plywood under refrigerator. 
4. Stand the refrigerator up. First, place the left bottom edge of 

the refrigerator on the floor, stand the refrigerator upright and 
then lower the right-hand side of the refrigerator to the floor. 

■

If a solid soffit is not available, anti-tip boards must be 
installed. 

■

It is recommended that boards be installed before the 
refrigerator is installed.

■

Boards must be long enough to fully cover the width of the 
compressor cover.

■

Place the boards so that the bottom surfaces of the boards 
are 84" (213 cm) from the floor.

■

During installation, raise the refrigerator up until the top of the 
refrigerator is making contact with the bottom of the anti-tip 
boards. Do not crush the compressor cover when raising the 
rear leveling legs.

NOTE: The foam gasket, on top of the compressor cover, will 
compress to fit under the anti-tip board(s). There is no need to 
trim the gasket. 

1. Mark the stud locations on rear wall.
2. Securely attach two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) 

boards to wall studs behind refrigerator. Use six #8 x 3" 
(7.6 cm) (or longer) wood screws. The wood screws must be 
screwed into the studs at least 1½" (3.8 cm). The boards must 
overlap the compressor cover.

Read all directions before you begin.
IMPORTANT: If you turn the refrigerator on before the water line is 
connected, turn the ice maker OFF.

■

Minimum 7 ft (2.13 m) flexible, codes-approved water 
supply line

NOTE: If your water line connection does not look like Style 1, see 
“Style 2—Copper Line Connection.”
1. Unplug refrigerator or disconnect power supply.
IMPORTANT: 

■

There is not enough clearance to achieve a flush installation if 
a water shutoff valve is located in the wall behind the 
refrigerator. The water shutoff should be located in the base 
cabinet on either side of the refrigerator.

■

Before attaching the tubing to shutoff valve, flush the main 
water supply line to remove particles and air in the water line. 
Allow enough flow so that water becomes clear. Flushing the 
water line may help avoid filters and/or water valves from 
becoming clogged. 

A

B

C

D