Jenn-Air W10735232A 사용자 설명서

5. Using slotted hex-head screws (provided with refrigerator) for 

each side, attach the door panels to the hinge-side door trims. 

6. Using Phillips-head flat screws (provided with refrigerator), 

install the handle side door trim.

7. Completely tighten the screws attaching the mounting 

brackets, located at the bottom of the doors, to the panels.

8. Reinstall the top door trim and hinge cover.
9. Snap the door adjustment pin cover (provided with 

refrigerator) into place.

10. If necessary, adjust the drawer panel to align and fully tighten 

all drawer panel screws.

There are two pieces to the base grille to allow for a custom fit: the 
base grille itself and the skirt. The skirt can be added to the base 
grille in order to extend it all the way to the floor.
1. To see whether the skirt is needed, place the base grille into 

position. Do not attach the base grille to the refrigerator. 
Measure the distance between the bottom of the base grille 
and the floor. The gap must be a minimum of 

¹⁄₂" (1.27 cm) in 

order to add the skirt. 
NOTE: If the gap measures less than 

¹⁄₂" (1.27 cm), skip 

steps 3 and 4 of the instructions, and install the base grille 
only.

2. Remove the film from the base grille.
3. Snap the skirt onto the base grille. 

4. Trim the skirt by scoring the proper “V” groove with a utility 

knife. Break the skirt at the score line.

.

5. Using the two screws, attach the base grille assembly to the 

refrigerator as shown.
NOTE: Drive in the right side screw first.

1. Turn the water supply line valve to the “Open” position. 
2. Turn the refrigerator switch to the ON position. See “Power 

On/Off Switch” in the Use & Care Guide for instructions. Wait 
a few minutes. Check the water line connections for leaks. 

3. Remove all boxes, parts packages and packing materials from 

the interior of the refrigerator. See the “Cleaning” section in 
the Use & Care Guide for instructions. Remove the film and 
cardboard from the grille and doors or door frame, depending 
on your model.

4. Install the shelves and bins in the refrigerator and freezer 

compartments.

5. The controls are preset at the factory to the midpoint setting. 

Check that the compressor is operating properly and that all 
the lights are working.

6. Flush the water system before use. See “Water System 

Preparation.”

To get the most efficient use from your new built-in refrigerator, 
read the Use & Care Guide. Keep Installation Instructions and Use 
& Care Guide near the built-in refrigerator for easy reference.

A

B

A

B

A