Jenn-Air W10735232A 사용자 설명서

■

Observe all governing codes and ordinances. 

■

It is recommended that you do not install the refrigerator near 
an oven, radiator, or other heat source. 

■

Do not install in a location where the temperature will fall 
below 55°F (13°C).

■

Floor must support the refrigerator weight, more than 600 lbs 
(272 kg), door panels and contents of the refrigerator. Flooring 
under refrigerator must be at same level as the room. Face of 
cabinetry must be plumb.

■

Ceiling height must allow for side tipping radius. See “Tipping 
Radius.”

■

Location should permit door to open fully. See “Door Swing 
Dimensions.” 

■

Location must permit top grille removal. See “Opening 
Dimensions.”

■

The width of the opening (Width A), from side to side, must be 
as specified for your model, for at least 2" (5.08 cm) back from 
the face of the cabinet.

NOTE: If your opening does not meet this requirement, you 
will need to make modifications.

■

A solid soffit or wall cabinet must be installed 84" (213.4 cm) 
above the floor. If the solid soffit is higher than 84" (213.4 cm) 
or one is not available, then the refrigerator must be braced. 

If anti-tip boards are needed, they must be attached to the 
rear wall studs so that there is 84" (213.4 cm) from the bottom 
of the anti-tip board to the floor. See “Install Anti-Tip Boards” 
for more information.

NOTES: 

■

A clearance of 

¹⁄₂" (1.3 cm) must be maintained above the 

top grille so that the top grille can be removed.

■

Do not remove the foam gasket from the top of the 
compressor cover unless removal is necessary to fit the 
unit under a soffit. Removal of the gasket will cause loss in 
cooling efficiency. 

■

If installing under a solid soffit, after installation raise the 
leveling legs so that the gasket is pressed snugly against 
the soffit. 

■

For a fully integrated installation, a minimum of 6" (15.24 cm) 
of open space above the refrigerator is required. See “Fully 
Integrated Installation.” Anti-tip boards are required. See 
“Install Anti-Tip Boards” for more information.

■

A grounded 3 prong electrical outlet should be located within 
a specified number of inches from the right-hand side 
cabinets or end panel. See the chart following the graphic for 
the number of inches required for your model. For more 
information, see “Electrical Requirements.”

RC Hinge Cover Trim

W10648975—36" BM 
(Right)
W10564251—36" FDBM 
(Right)
W10606804—42" FDBM 
(Right)

FC Hinge Cover Trim

W10611107—36" BM (Left)
W10582015—36" FDBM (Left)
W10606808—42" FDBM (Left)

Panel Templates 

W10222281—SxS
W10488115—36" BM
W10704869—36" FDBM
W10488118—42" FDBM
W10489178—Grille

Handle Side Door Trim

W10611106—BM (Left)
W10648977—BM (Right)
W10606802—FDBM (Right) 
W10606806—FDBM (Left)

Installation Block

Grille—Bottom / Skirt—Grille

W10189198 / W10188549—42" BM
W10189196 / W10188547—36" BM

B

A