Jenn-Air W10379136B 사용자 설명서

IMPORTANT: The grille panel height, shown in the “Standard 
Integrated Grille Installation—Side View” graphic, allows for an air 
gap critical to refrigerator performance.

■

Do not remove the film covering until the refrigerator is in its 
operating location.

■

All four leveling legs must contact the floor to support and 
stabilize the full weight of the refrigerator.

■

Keep the cardboard shipping piece or plywood under the 
refrigerator until it is installed in the operating location.

1. Remove and save the literature package and hardware kit 

located inside the refrigerator. Remove and save the 
literature, grille, and trim taped to the outside of the 
refrigerator. 

NOTE: Do not remove tape and door bracing until the 
refrigerator is in its final location.

1. Place an appliance dolly under the left side of the refrigerator 

as shown. Place the corner posts from the packing materials 
over the trims as appropriate. Slowly tighten the strap.

2. Place pieces of the shipping carton on the floor when rolling 

the dolly and refrigerator into the house. Move the refrigerator 
close to the built-in opening.

3. Place top of cardboard carton or plywood under refrigerator. 

4. Stand the refrigerator up. First, place the left bottom edge of 

the refrigerator on the floor, stand the refrigerator upright and 
then lower the right-hand side of the refrigerator to the floor. 

5. Reassemble the trim and top grille after the dolly has been 

removed from the refrigerator.

Top Grille Panel

Top Grille Filler

41

¹⁄₄"

(104.78 cm)

41

³⁄₄"

(106.05 cm)

47

¹⁄₄"

(120.02 cm)

47

³⁄₄"

(121.29 cm)

41

¹⁄₄"

(104.78 cm)

41

³⁄₄"

(106.05 cm)

47

¹⁄₄"

(120.02 cm)

47

³⁄₄"

(121.29 cm)