Makita EK7650H 사용자 설명서

P  5/ 19

Assemble their parts by reversing the disassembly procedure.

(1) Assemble one of Ball bearing 6203LLU to Cutting holder, then snap Retaining ring R-40 into the groove of 

      Cutting device to secure the bearing.

(2) Insert Spindle into the other Ball bearing 6203LLU, then assemble them to Cutting device until they stop.

Note: Use two 1R030 as drawn in Fig. 7 so that their inner retainers of Ball bearings 6203LLU can be held without load 

           to the other portions.

          This retains the proper tensions to their inner retainers.

(3) Insert Lock shaft into the place of Cutting device, then set Sliding disc and Impact plate. Push Lock shaft from

      Belt cover side toward Blade installation side until the top bumps against Impact plate. (Fig. 8)

(4) Belt tension must be adjusted by turning M6 Tension screw clockwise until M6 Hex nut is aligned to a line between 

      plus mark and minus mark. (Fig. 9.)

(5) Holder of Water supply set can be set to Belt cover by turning clockwise/ counterclockwise to 90° .  

ASSEMBLING

1R030 to hold the inner retainer

of Ball bearing 6203LLU

1R030 to hold the inner retainer

of Ball bearing 6203LLU

Impact plate

Lock shaft

M6 Square nut

Line

M6 Tension screw

Belt cover

Align the flat end of 

Impact plate to that of 

Hood complete.  

Holder