GE TCX22 사용자 설명서

Water Supply to the Icemaker 

(on some models)

If the refrigerator has an icemaker, it will have to be

connected to a cold water line.

A water supply kit (containing copper tubing,

shutoff valve, fittings and instructions) is available 

at extra cost from your dealer or from Parts and

Accessories, 800-626-2002.

Refrigerator Location

Do not install the refrigerator where the

temperature will go below 60°F (16°C) 

because it will not run often enough to maintain

proper temperatures.

Install it on a floor strong enough to support it 

fully loaded.

Clearances

Allow the following clearances for ease of

installation, proper air circulation and 

plumbing and electrical connections:

Sides  . . . . . . . . . . . . . . . . . . . . . . . .1

″

(25 mm)

Top  . . . . . . . . . . . . . . . . . . . . . . . . .1

″

(25 mm)

Back . . . . . . . . . . . . . . . . . . . . . . . . .1

″

(25 mm)

Rollers adjust so the door closes easily when

opened about halfway. [Front of refrigerator

should be 1/4

″

(6 mm) higher than the rear of

refrigerator.]
Rollers adjust so the refrigerator is firmly

positioned on the floor and does not wobble.
Rollers allow you to move the refrigerator away

from the wall for cleaning.

Remove the base grille.

Turn the roller

adjusting screws
clockwise to raise

the

refrigerator, counter-
clockwise to lower it.
Use a 3/8

″

socket

wrench or adjustable

wrench. Replace the

base grille.

Remove the base grille 

by grasping it at the

bottom and pulling it

straight out.

To replace the base 

grille, align prongs on

back of grille with slots

in cabinet and push

forward until the grille

snaps into place.

Roller Adjustment Screw
(3/8

″

hex with slot)

Roller

Stabilizing
Brake

11