Maytag W10558103A 사용자 설명서

Accessories

FILTERS AND ACCESSORIES

Water Filtration System

Install the Water Filter

1. Locate the accessory packet in the refrigerator and remove 

the water filter. 

2. Take the water filter out of its packaging and remove the 

cover from the O-rings. Be sure the O-rings are still in place 
after the cover is removed.

3. The water filter compartment is located in the right-hand side 

of the refrigerator ceiling. Push up on the compartment door 
to release the catch, then lower the door. 

4. Align the arrow on the water filter label with the cutout notch 

in the filter housing and insert the filter into the housing.

5. Turn the filter clockwise 90 degrees (

¹⁄₄ turn), until it locks into 

the housing.

NOTE: If the filter is not correctly locked into the housing, the 
water dispenser will not operate. Water will not flow from the 
dispenser. 

6. While the compartment door is still open, lift the filter up into 

the compartment. Then, close the filter compartment door 
completely.

7. Flush the water system. See “Flushing the Water Filter” in the 

“Water and Ice Dispensers” section.

IMPORTANT: If you do not flush the water system, you may 
experience dripping and/or decreased flow from the water 
dispenser. 

The Water Filter Status Light

Press WATER FILTER to display the percentage of filter life 
remaining (from 99% to 0%). Press WATER FILTER again to 
return to the Normal screen. 

The water filter status lights will help you know when to change 
your water filter. 

■

ORDER (yellow) - it is almost time to change the water filter. 

■

REPLACE (red) - Replace the water filter. While you are 
dispensing water, “Replace” will blink.

NOTE: If a water filter is not installed or is undetected 
because it is not properly installed (locked into place), 
“Replace” and “--% remaining” will display on the control 
panel. Check the water filter.   

■

RESET the water filter status tracking feature. After you 
replace the disposable filter with a new filter, closing the filter 
compartment door will automatically reset the filter status 
tracking feature. See “Using the Controls.”

NOTE: “Replace” will remain illuminated if a filter is not 
installed or is installed incorrectly.

Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.

B

A