Electrolux 318201761E30GF74GPS 사용자 설명서

Installation

CONNECT RANGE TO GAS SUPPLY

INSTALLING THE RANGE

Measure from the floor to the countertop and adjust the leveling legs as required to position
the top frame at the desired height, based on the cabinet and countertop installation.
Carefully slide the range into position in the cutout.

Installing the burner components

Remove the burner bases, burner heads, burner caps, and porcelain grates from their
shipping packages. Place each burner onto its corresponding burner base, being certain
that the burners align with the ignitor correctly. Set each burner cap on top of its
corresponding burner head. Place each grate onto the top frame.

Make sure the anti-tip bracket is installed as directed on page 14.

1. Slide range forward.
2. Make sure the anti-tip bracket is securely attached to

the wall behind the range.

3. Safely slide the range slightly and move back against wall, making sure the

pin slides under bracket.

WARNING

The 30” and 36” ranges require an Anti-Tip device. Before installing the range, you must locate and
secure the Anti-Tip bracket to the floor.

WARNING

•

Do not apply excessive pressure when tightening gas connections and fittings.

•

Do not use teflon tape or plumber’s putty on gas flex line connections.

•

Turn all control valves to the “OFF” position. Turn on gas supply and check all lines and
connections with leak detector, such as soap and water solution. Do not use flame to
check for leaks. After verifying that there are no gas leaks, turn off the gas supply to the
range by turning the gas shut-off valve to the “OFF” position.

•

For LP installations, the LP gas tank must have its own high pressure regulator. This is in
addition to the pressure regulator provided with the range.

•

The maximum gas supply pressure to the regulator must never exceed 1/2 pound per square

WARNING

Never attempt to operate the cooktop section of the range with any of the burner caps or grates
removed.