Dacor DR30ES 사용자 설명서

Installation Instructions

Re-installing the Oven Door

falling off its hinges:
•  Make sure that the notch on the bottom of each hinge rests 

on top of the lower lip of each hinge receptacle before 

attempting to open the oven door.

•  Rotate the hinge locks toward the front of the range 

immediately after installation of the door.

1.  Grasp the oven door on opposite sides and hold it at a 15° 

angle from the front of the range. Slide the hinges into the 

hinge openings, resting the bottom of the hinge arms on the 

hinge receptacles. Continue to hold the door at a 15° angle 

with one hand while pushing in on each of the bottom corners 

of the door. Push until the notch on the bottom of each hinge 

slips over the lower lip of each hinge receptacle.

2.  Lower the door to the fully opened position.
3.  Rotate the two hinge locks toward the range.
4.  Slowly and carefully open and close the door completely to 

ensure that it is properly installed.

Installing the Range

Peel off the protective layer of plastic that covers the stainless 

steel surfaces.

1.  Measure from the floor to the countertop and adjust the 

leveling legs as required to position the top frame at the 

desired height, based on the cabinet and countertop 

installation.

2.  Carefully slide the range into position in the cutout. As you 

slide the unit into place the rear leg should engage the anti-

tip bracket.

3.  Using a flashlight look underneath the range and verify that 

the anti-tip bracket covers the rear leg. See diagram below.

4.  Use a level to make sure that the range does not tilt front to 

back or side to side. Re-adjust the legs to level and change 

the height if necessary.

Installation of the range in the self-rimming configuration is 

slightly different from freestanding installation since the range top 

overhangs the countertop cutout.
1.  Measure from the floor to the countertop.
2.  Adjust the leveling legs to position the bottom edge of the 

range top trim at countertop height.

3.  Carefully slide the range into position in the cutout. As you 

slide the unit into place the rear leg should engage the anti-

tip bracket.

4.  Using a flashlight look underneath the range and verify that 

the anti-tip bracket covers the rear leg. See diagram below.

5.  Use a level to make sure that the range does not tilt front to 

back or side to side. Re-adjust the legs to level and change 

the height if necessary.

Anti-tip 

bracket

Rear leg