VIVOTEK 63E-M 사용자 설명서

 

 

Advanced Mode

This section explains how to control the Network Camera’s Pan/Tilt/Zoom operation. 

The camera comes with built-in PTZ mechanisms. 

Preset positions and patrol settings 

In the PTZ settings page, you can select preset positions for the camera to patrol. A total of 256 preset 

positions can be configured.  

Please follow the steps below to configure preset positions and arrange them in a pan/tilt/zoom tour:

1. Adjust the shooting area to the desired position using the keypad on the upper right side of the 

window. The default

 Home position refers to the center position defaulted in the factory. You might as 

well select another area of interest as the “Home“ position. You should also select the speeds for the 

actions that occur during the patrol; i.e., pan, tilt, zoom, focus, and the auto pan/patrol.    

2. Enter a name for a new preset position, which can contain up to forty characters. Click 

Add to enable 

the settings. The preset positions will be listed on the 

User preset locations. (To add positions you 

wish, please repeat steps 1~2.)

3. Select the preset positions and click on the 

Save button at the bottom of the screen. 

4. Click on the move button (>>) 

 to move positions to the Patrol locations window. 

5. You may select some or all of the imported positions as the stop points during the tour. 

6. Enter a preferred dwell time before the camera lens moves to the next position.   

7. Select a

 speed level for the auto patrol tour. 

8. Click on the

 Save button to preserve your configuration. 

To remove a preset position from the list, select it and click 

Remove.

You can re-arrange the patrol order of the positions on the list using the 

 buttons. 

The navigation buttons here also 

support the continuous move. You 

can click and hold down the button 

to move across the screen until you 

release the button.