John Deere AC-CP2GH 사용자 설명서

Centrifugal Pump Operator's Manual

HOW TO USE

1. Ensure pump is fully filled up with water.
2. Ensure strainer at the end of suction hose is in water. (if any mud or sand is at the

bottom of water, suspend hose above the bottom.)

3. Ensure no one or anything that can be damaged by water, is not in front of the

discharge hose end.

STARTING AND OPERATING ENGINE

CAUTION: DO NOT RUN ENGINE IN AN ENCLOSED AREA.

EXHAUST GAS CONTAINS CARBON MONOXIDE, AN

ODORLESS AND POISONOUS GAS THAT CAN CAUSE

SICKNESS OR DEATH.

IMPORTANT: DURING FIRST TWO HOURS OF ENGINE OPERATION,

ENGINE MAY OPERATE AT LOW OR ERRATIC RPM AS THE ENGINE

MOVING PARTS BREAK IN.

1. Set fuel valve lever (A) right to ON

position.

2. Move choke control lever (B) left to

“CHOKE” position.
NOTE: A warm engine requires less

choking than a cold engine.

3. Move throttle lever (C) left to the fast

position.
NOTE: For best engine performance

it is recommended the engine be

operated with the throttle in the

FAST position.

4. Turn the engine switch (D) to “ON” to

position.

5. Pull recoil starter grip lightly until

resistance is felt, then pull briskly until
engine starts.

IMPORTANT: DO

NOT

ALLOW

STARTER GRIP TO SNAP BACK

AGAINST ENGINE. RETURN

IT GENTLY TO PREVENT

DAMAGE TO STARTER.

6. Move “CHOKE” control lever (B) right to

open position as soon as engine warms
up enough to run smoothly. If engine is
warm, move choke lever right as soon
as engine starts.

Operation