Avaya 555-231-743 사용자 설명서

Issue 1

November 2000

Translations and Testing 

158

Switch-to-INTUITY Translations 

The TCP/IP signaling link requires administration on both the switch and the 
INTUITY. Any switch type (csi, si or r) can use a TCP/IP link. The TCP/IP link 
supports the PMS Interface for GuestWorks (see 

). This section includes 

procedures for testing the link.

On the switch, you must do the following to administer the TCP/IP link:

1.

Assign the bus bridge (

csi systems only)

2.

Assign node names

3.

Assign IP interfaces

4.

Assign an ethernet data module

5.

Assign a processor interface channel

6.

Assign IP routes (if needed).

Assign the Bus Bridge (csi Systems Only)

Using the change system-parameters maintenance command, Page 2, verify 
that the Bus Bridge Packet Interface 2 has been enabled for the C-LAN circuit 
pack. If it is not already assigned, enter the C-LAN circuit pack equipment 
location, and use the defaults for the Timeslot Port fields as shown below.

change system-parameter maintenance

Page 2 of 4

MAINTENANCE-RELATED SYSTEM PARAMETERS

MINIMUM MAINTENANCE THRESHOLDS ( Before Notification )

TTRs: 4 

CPTRs: 1 

Call Classifier Ports:

MMIs: 0 

VCs:

TERMINATING TRUNK TRANSMISSION TEST (Extension)

Test Type 100: 

Test Type 102: 

Test Type 105:

ISDN MAINTENANCE

ISDN-PRI TEST CALL Extension: 

 ISDN BRI Service SPID: 

DS1 MAINTENANCE

DSO Loop-Around Test Call Extension: 

LOSS PLAN (Leave Blank if no Extra Loss is Required)

Minimum Number of Parties in a Conference Before Adding Extra Loss: