Weber Built-In LP Gas Grill 사용자 설명서

3

WWW.WEBER.COM

®

3

GENERAL CONSTRUCTION DETAILS

Summit

®

 Built-In unit and all other accessory units should be on site before construction 

begins.

All dimensions have a tolerance of plus or minus (+/-) 1/4 inch (6.35 mm).

The grill frame rests directly on the Island Structure top fi nished surface. Make 
sure this surface is level. Do not support the grill from the bottom. 

 

If the supporting structure is going to have an electrical outlet for a 
rotisserie, it should be on the left side of the structure.

Refer to Summit

®

 Built-In Tank Drawer Installation Instructions for 

complete gas line locations.

BUILT-IN STRUCTURE CUTOUT DIMENSIONS
ALL DIMENSIONS ARE TO FINISHED SURFACES.

BUILT-IN CUTOUT DIMENSIONS

S-440

S-640

TOLERANCES

30 1/4˝ (768.35 mm)

38 1/4˝ (971.55 mm)

+ 1/4˝   - 

1/

4˝ (6.35mm)

34 3/8˝ (873.13 mm)

34 3/8˝ (873.13 mm)

+ 1/4˝   - 

1/

4˝ (6.35mm)

23˝ (584.2 mm)

23˝ (584.2 mm)

+ 1/4˝   - 

1/

4˝ (6.35mm)

BUILT-IN CUTOUT DIMENSIONS

S-440

S-640

DIMENSIONS

24” minimum* (610 mm)

24” minimum* (610 mm)

3 3/4” (95.25 mm)

3 3/4” (95.25 mm)

6 1/4” (158.75 mm)

6 1/4” (158.75 mm)

10 1/2” (266.7 mm) minimum

10 1/2” (266.7 mm) minimum

23” (584.2 mm)

23” (584.2 mm)

34 3/8” (873.13 mm)

34 3/8” (873.13 mm)

27” (685.8 mm) minimum distance from front edge of

the cutout for open lid clearance

27” (685.8 mm) minimum distance from front edge of

the cutout for open lid clearance

30 1/4” (768.35 mm) Built-In Frame 

38 1/4” (971.55 mm) Built-In Frame

Note: For a countertop treatment: Recommended 3/4” (19.1 mm) overhang. Notch front edge for frame to fully slide in.

Gas Inlet

Side Burner Opening

Access for electric on left hand side

BUILT-IN CUTOUT DIMENSIONS