KitchenAid KFGR271SSS 사용자 설명서

다운로드
페이지 24
22
    U-shaped burners
* Clean the exterior of the burner with a wire brush.
*  Clear any clogged burner ports with a straightened paper clip. 
Never use a toothpick as it may break off and clog the port. 
*  Use a fl ashlight to inspect into the burner through the burner 
inlet to ensure there is no blockage. If any obstruction is seen, 
use a metal coat hanger that has been straightened to clear 
them. 
After inspecting the inside of burner for blockage, reassemble 
burner by sliding the middle tube of burner over orifi ce. Insert tabs 
on the burner bracket into the holes in burner support.
burner bracket
tab
burner support
orifi ce
holes
The full-width drip tray collects grease and food particles that fall 
through the grill. Remove tray and set on a fl at surface. 
• Wipe excess grease with paper towels.  
•  Use mild detergent, warm water. Rinse and dry thoroughly. 
Replace tray.
• Clean often to avoid grease build-up. 
    Knobs, plastic and fl ange area around knobs
IMPORTANT: Do not use steel wool, abrasive cleaners, or oven 
cleaner. 
Do not soak knobs.
•  Wash with mild detergent, using a soft cloth and warm water. 
Rinse and dry. 
   Control panel graphics
IMPORTANT: Do not use steel wool, abrasive cleaners or oven 
cleaner.
Do not spray cleaner directly onto panel.
Clean around the burner labels gently; scrubbing may remove 
printing.
•  Wash with mild detergent, using a soft cloth and warm water. 
Rinse and dry. 
   Rotisserie spit rod handle 
   (On some models)
• Do not use steel wool, abrasive cleaners or oven cleaner.
•  Wash with mild detergent, using a soft cloth and warm water. 
Rinse and dry.
   Rotisserie spit rod and forks
 
   (On some models)
•  Wash with mild detergent, using a soft cloth and warm water. 
Rinse and dry. 
•  For stubborn areas, use a multi-purpose cleaner, a heavy-duty 
scrub sponge or mild abrasive cleaner.
 
Accessories
Custom Access Door Kits are available from your dealer.
    27” (68.6 cm): Door Kit No. KBAD271SSS
    30” (76.2 cm): Door Kit No. KBAD301SSS
    36” (91.4 cm): Door Kit No. KBAD361SSS
Vinyl Grill Covers are available from your dealer.
    Built-in models:
    27” (68.6 cm): Cover No. 4396323
    36” (91.4 cm): Cover No. 4396325
    Portable models:
    27” (68.6 cm): Cover No. 4396324
    36” (91.4 cm): Cover No. 4396326
    48” (121.9 cm) [36” (91.4 cm) grill with side burner]: 
    Cover No. 4396634
Rotisserie kits for portable (freestanding) grills are available from 
your dealer.
    27” Rotisserie Kit No. KFRK271SSS
    36” Rotisserie Kit No. KFRK361SSS
•  Cleaning should always be followed by rinsing with clean warm 
water.
• Wipe the surface completely dry with a soft cloth.
•  For tough spots or baked-on grease, use Whirlpool Degreaser 
(Part No. 31552), a commercial degreaser designed for stainless 
steel. See “Requesting Assistance or Service” section to order.
   Interior
Discoloration of stainless steel on these parts is to be expected, 
due to intense heat from the burners. 
•  Cleaning should always be followed by rinsing with clean, warm 
water. 
•  Use a mild liquid detergent or all-purpose cleaner, following label 
instructions. Rinse with clean water and dry completely with a 
soft, lint-free cloth.
•  A heavy-duty scrub sponge can be used with mild cleaning 
products. Always rub in the direction of the grain.
•  For small, diffi cult-to-clean areas, use Whirlpool Degreaser (Part 
No. 31552), a commercial degreaser designed for stainless steel. 
See “Requesting Assistance or Service” section to order.
   Side burner caps and grate
• Clean with a brass bristle brush. 
• Wash grate using mild detergent, warm water and degreaser.
• Rinse with clean water and dry with soft, lint-free cloth.
•  Use Stainless Steel Cleaner & Polish (Part No. 4396095). See 
“Requesting Assistance or Service” section to order.
    Drip tray 
IMPORTANT: The drip tray should only be removed when grill is 
completely cool.