Cal Flame LTR20091006 사용자 설명서
Installation /
Assemb
ly
9
2009 Fireplaces and Firepits
LTR20091006, Rev. B
www.calspas.com
Connection
Inspect the hose shipped with the unit for damage. Never attempt to
Inspect the hose shipped with the unit for damage. Never attempt to
use damaged or plugged equipment. See your local LP gas dealer for
repairs. After inspecting the LP hose shipped with the unit, connect the
end with the female fitting on the hose to the male fitting on the on/off
gas valve at the end of the hose. Tighten fittings using two wrenches.
When connecting the regulator assembly to the tank valve, hand tight-
When connecting the regulator assembly to the tank valve, hand tight-
en the black QCC-1 nut clockwise. DO NOT use a wrench to tighten.
See the figure below.
Purge the gas supply line of any trapped air prior to the first firing of
Purge the gas supply line of any trapped air prior to the first firing of
the unit.
During the initial purging and subsequent lightings, NEVER allow gas
During the initial purging and subsequent lightings, NEVER allow gas
to remain in the “Open” position without first placing and igniting the
fire starter.
Locate the hose out of the pathways where people may trip over it or in
Locate the hose out of the pathways where people may trip over it or in
areas where the hose may be subjected to accidental damage.