Aussie 8362 사용자 설명서

Clean paint brush, water, and dishwashing liquid

1) Mix one cup of water with one cup of 

dishwashing liquid.

2) Confirm that all control knobs on the control

panel are in the off position.

3) Remove control knobs and the three retaining

screws at the bottom of the control panel.

4) Remove front control panel cover.
5) Open valve on LP gas cylinder (Turn counter  -

-clockwise.)

6) Check for leaks by brushing the soap solution

on all LP gas connections and fittings. Make sure
you generously brush the locations shown below
with the soap solution, completely surrounding
the connections and fittings (See diagram
below.)

7) If “growing” bubbles appear on any of the

connection points, you have detected a gas leak.
Immediately close the LP cylinder valve.

A) If leak appears at either end of hose and
regulator assembly, retighten the connection at
the leak, but do not overtighten.  (Note: only
hand tighten at coupling nut.) Repeat Leak Test.
B) If the leak is coming from the LP gas cylinder,
from the valves at the control knobs, or if the
leak cannot be stopped, do not use the grill. Call
Customer Service at 1-800-251-7558.

8) Always turn off LP cylinder valve after perform-

ing a leak test. (Turn clockwise to a full stop.)

9) If your LP gas grill has been in storage or has

not been used for a period of time, the burners
shoulder be maintained. See Burner
Maintenance in the Care and Maintenance
section of this  manual.

12