Vermont Casting DVT38IN 사용자 설명서

26

1.  Turn the fireplace OFF (including the pilot).
2.  If the unit has been operating allow time for the 

components to cool.

3.  Using a Phillips screwdriver, unfasten two (2) screws 

located at the top of the glass frame. (Fig. 35) 

4.  Tilt the glass frame at the top away from the unit. 

Lift it carefully off the bottom door track and set on 
padded surface.

It is necessary to periodically clean the glass. During 
start-up, condensation, which is normal, forms on the 
inside of the glass. This condensation causes lint, 
dust and other airborne particles to cling to the glass 
surface.
Also initial paint curing may deposit a slight film on 
the glass. It is therefore recommended the glass be 
cleaned two or three times with a non-ammonia based 
household cleaner and warm water (gas fireplace glass 
cleaner is recommended) within the first few weeks of 
operation.
After the initial cleaning process the glass should be 
cleaned two or three times during each operating 
season depending on the environment in the house.

• 

The use of any non-approved replacement glass will 
void all product warranties.

• 

Care must be taken to avoid breakage of the glass.

• 

• 

Refer to Figures 14, 15 & 17 for your venting configura-
tion and combination of restrictor plate requirement and 
fresh air restrictor plate adjustment.
Restrictor Plate Installation
Using the two (2) screws provided along with the restic-
tor plate shipped with the logset, fasten the restrictor 
plate to the firebox top through the front of the unit. (Fig. 
36)
Fresh Air Restrictor Plate Adjustment
1.  Remove the glass.
2.  Remove the logs, andirons and fettle. 
3.  Remove one side refractory (right or left) and re-

move the rear upper and lower refractory in reverse 
order of installation. (Refer to “Ceramic Refractory 
Installation” section.)

4.  Remove the rear log bracket by removing three (3) 

screws. On some models you may be able to loosen 
the screws and slide bracket to the left and out. (Fig. 
37)

5.  Adjust the fresh air restrictor plate setting. (Fig. 38) 

Simultaneously install the plate and the log bracket 
using the three (3) screws loosened or removed ear-
lier. The adjustment is made by matching the proper 
setting on the plate with the three (3) holes on the 
firebox back.

Phillips 

Screws

FP1558a

Fig. 35   Remove Phillips screws, tilt frame forward and lift off 
bottom door track. (Shown without logs for clarity.)

������
������������
����

�������

�

��������������

������������

������������������

�������������

��������������������

���������������