Polycom SIP 2.2.0 사용자 설명서

다운로드
페이지 254
 Configuring Your System
4 - 43
jitter buffer is adaptive and configurable for different network environments. 
When packets are lost, a concealment algorithm minimizes the resulting 
negative audio consequences.
Configuration changes can performed centrally at the boot server or locally:
Voice Activity Detection
The purpose of voice activity detection (VAD) is to conserve network 
bandwidth by detecting periods of relative “silence” in the transmit data path 
and replacing that silence efficiently with special packets that indicate silence 
is occurring. For those compression algorithms without an inherent VAD 
function, such as G.711, the phone is compatible with the comprehensive 
codec-independent comfort noise transmission algorithm specified in RFC 
3389. This algorithm is derived from G.711 Appendix II, which defines a 
comfort noise (CN) payload format (or bit-stream) for G.711 use in 
packet-based, multimedia communication systems. The phone generates CN 
packets (also known as Silence Insertion Descriptor (SID) frames) and also 
decodes CN packets, efficiently regenerating a facsimile of the background 
noise at the remote end.
Configuration changes can performed centrally at the boot server:
DTMF Tone Generation
The phone generates dual tone multi-frequency (DTMF) tones in response to 
user dialing on the dial pad. These tones are transmitted in the real-time 
transport protocol (RTP) streams of connected calls. The phone can encode the 
Central 
(boot server)
Configuration file: 
sip.cfg
Set the jitter buffer tuning parameters including minimum and 
maximum size and shrink aggression.
For more information, refer to 
 on 
Local
Web Server 
(if enabled)
Set the jitter buffer tuning parameters including minimum and 
maximum size and shrink aggression. 
Navigate to http://<phoneIPAddress>/coreConf.htm#au
Changes are saved to local flash and backed up to <Ethernet 
address
>-phone.cfg on the boot server. Changes will permanently 
override global settings unless deleted through the Reset Local 
Config menu selection and the <Ethernet address>-phone.cfg is 
removed from the boot server.
Central 
(boot server)
Configuration file:  
sip.cfg
Enable or disable VAD and set the detection threshold. 
For more information, refer to 
 on