Windsor PJ2AIE 사용자 설명서

86037500 PJ2A 03/04/08 

1.  Vacuum unused cleaning solution from solution tank into recovery bucket. 
2.  Flush two gallons of clean water through pumping system of extractor, PILEJOGGER and hand tools.  Twice 

a month, flush a vinegar solution (one quart white vinegar to two gallons water) or browning prevent solution 
(mixed as directed) through extractor and PILEJOGGER.  This will minimize buildup of alkaline residue in the 
system. 

3.  Remove carpet lint from brush fibers and underside of brush housing.  Flush out with water.   
4.  Check for carpet lint buildup in vac shoe.  Clean out and flush with water. 
5.  If spray jets become clogged, remove from manifold, wash and blow-dry to remove obstruction.  Do not use 

pins, wires, etc. to clean jets as this could destroy spray pattern. 

6.  Apply silicone lubricant to quick-disconnect fittings. 
 

 

PROBLEM. 

Dead electrical circuit 

Check building circuit breaker or fuse box 

Faulty switch 

Replace 

Faulty electrical cable 

Replace 

Faulty motor 

Replace 

Faulty switch 

Replace 

Loose cuff on vac hose 

Tighten cuffs (turn counterclockwise) 

Vac chamber plugged 

Wash out with hose.  Pick lint out with wire. 

Broken vac hose 

Replace 

Corrosion on fittings 

Clean fitting by soaking in vinegar solution, lubricate 
lightly with silicon lube 

Faulty solution valve 

Repair or replace 

Corrosion 

Clean with steel wool and vinegar solution; wipe dry 
after each use. 

Severe soil conditions 

Make more than one pass at right angle to first pass.  
Prespray. 

Loss of vacuum 

Check vac system for leaks