Windsor PJ2A 사용자 설명서
OPERATIONS
86037500 PJ2A 03/04/08
3-1
USING PILEJOGGER II WITH
EXTRACTOR
1. Connect vacuum and solution hoses to
PILEJOGGER.
2. Plug power cord into properly grounded
outlet.
3. Move PILEJOGGER to starting place. Turn
on brush drive motor by depressing foot
switch located on top of cleaning head.
Depress solution valve lever fully and move
backward at a steady pace (25 to 30 feet
per minute).
NOTE: Lift the handle slightly as you move
backward so the weight is almost off the
rear roller. This will bring the vacuum orifice
and brush into proper contact with carpet.
switch located on top of cleaning head.
Depress solution valve lever fully and move
backward at a steady pace (25 to 30 feet
per minute).
NOTE: Lift the handle slightly as you move
backward so the weight is almost off the
rear roller. This will bring the vacuum orifice
and brush into proper contact with carpet.
4. Release solution valve lever approximately
6 inches before reaching the end of the
cleaning pass to ensure that all solution is
extracted.
cleaning pass to ensure that all solution is
extracted.
5. Make the next cleaning pass beside the
first, overlapping about 1 inch.
6. Reverse direction and clean balance of
room.
CAUTION: To prevent possible damage to
the carpet, never let the PILEJOGGER
stand in one place with the brush running.
CAUTION: To prevent possible damage to
the carpet, never let the PILEJOGGER
stand in one place with the brush running.