Pioneer VSX-AX5i-G 사용자 설명서

En

The area in which you can use the remote control to operate the VSX-AX5i is fairly large. To use, point the remote 
control toward the remote sensor on the front panel of this unit while within the range shown below.

Remote control may not function properly if:
• There are obstacles between the remote control and 

the remote sensor.

• Direct sunlight or fluorescent light is shining onto the 

remote sensor.

• The receiver is located near a device emitting infrared 

rays.

• Operated simultaneously with another remote control 

which uses infrared rays.

To open the front panel push gently on the lower third of the panel with your finger.

This receiver is able to use two types of video systems for its OSD (on screen display) either PAL or NTSC. If you don't 
match the system on the amplifier with your home system no OSD will appear on your TV. The default setting is PAL. 
If you use this system you don't need to make any settings here. People with multi-system TVs don’t need to worry 
about changing the setting either. If necessary, follow the instructions below to switch the type of video system.

The video system type will change depending on the state 
the receiver was previously in. The new type, either PAL or 
NTSC, will appear in the display. It will be shown for about 
seven seconds and then the receiver returns to normal 
operating mode.

VSX-AX5i.book  Page 8  Friday, May 23, 2003  6:33 PM