Britax 85 SICT 사용자 설명서
10
11
Adjuster
Latch
Plate
Lap Belt
IMPORTANT: A Lap belt may
only be used to install the child
seat in harness mode and should never be used to secure your
child in booster mode.
5.
ALR (Automatic Locking Retractor)
a
Has a latch plate that is
sewn into the webbing.
b
Has a retractor that stops the
belt from being pulled out
again once the belt webbing
has been pulled out at least
24 in. (61 cm).
c
Tightens by feeding the
belt webbing back into the
retractor.
6.
Locking Latch Plate
a
Has a latch plate that
does not allow the belt to
become loose after it is
buckled.
b
Tightens by pulling on the
belt webbing.
Vehicle Buckle Positions
If the buckle lies near the incorrect position ( ) when
the vehicle belt is tightened, try fitting the child seat
in another seating position in the vehicle. If it is not
possible to achieve the correct position ( ) for the
buckle, then another seating position MUST be used.
WARNING!
The position of the vehicle
belt buckle can adversely affect the stability
of the child seat.
Incompatible Vehicle Seat Belts
WARNING!
The following types of vehicle seat belts are NOT
compatible with this child seat. If any of the belt types listed below are
in the chosen seating position, choose another vehicle seating position
or check your vehicle owner’s manual for information on installing a car
seat in your vehicle.
1
Lap-shoulder belts
with top or bottom
anchor points on
the vehicle door.
2
Motorized,
automatic vehicle
seat belts.
3
Lap-shoulder
belts that have a
separate retractor
each for the
lap section and
shoulder section.
4
Inflatable lap-
shoulder belts.
5
Lap belts forward
of the vehicle seat
bight.
6
Lap belts with a
sewn-in latch plate
that have a retractor
that locks only in case
of a sudden stop.
Latch
Plate
Vehicle Compatibility
Vehicle Compatibility