Combi Victoria 8850 사용자 설명서

Thread vehicle lap belt or vehicle lap and shoulder belts through the rear-facing belt path
in the seat (fig. b):

- Thread vehicle seat belt through rear-facing belt path openings identified by the blue

“Belt Here” arrows.

- Buckle seat belt and remove any slack in the vehicle seat belt. Be sure vehicle seat 

belt is not twisted.

Tighten vehicle seat belt to secure the car seat. 

- Press down in center of car seat to depress the vehicle cushion while tightening vehicle 

seat belt (fig. c).

Check recline angle of car seat. Recline reference line on side of seat MUST be horizontal 
(fig. d). If recline reference line is not horizontal, place tightly rolled up towel, blanket or firm 
foam (pool noodle) under end of car seat base contacting vehicle seat back (fig. d). 

If car seat can not be adjusted to make line horizontal:

1.  Try a different seating position.
2. Do not use this car seat.

NOTE: Vehicle must be parked on horizontal surface and child in car seat when checking 

angle of car seat.

Check for secure installation. Gripping car seat at top of armrest, pull car seat front to back 
and left to right to check for secure installation (fig. e). Vehicle lap belt MUST stay tight.

- If vehicle lap belt does not stay tight or car seat can not be securely installed, 

see vehicle owner’s manual, “Vehicle Seat Belts” section or move to a different 
seating location.

Recheck recline angle of car seat. Adjust if necessary (see step 6).

Unbuckle vehicle seat belt.

- Pressing down in center of car seat to reduce tension on vehicle 

seat belt will make it easier to loosen vehicle seat belt.

Remove vehicle seat belt from belt path.

The Victoria Car Seat is color coded to identify adjustment positions and vehicle belt path locations for both rear-facing 
and forward-facing use. Forward-facing adjustments and the vehicle belt path are color coded with red. Rear-facing 
adjustments and the vehicle belt path are color coded with blue. 

Infants MUST be at least one year old and 20 lbs. (9 kg) to be forward-facing.

Shoulder harness position:

a. Use only the middle and top two sets of harness strap slots forward-facing (fig. a).

b. Harness covers MUST be used when forward-facing.

c. Shoulder harness MUST be through slots at or above shoulders of child.
To change shoulder harness slots, see “Changing Harness Position” section.

Seat recline:

a. Use only recline positions #2, 3, or 4 when using car seat forward-facing.
b. Seat recline position can be adjusted between positions without unsecuring 

vehicle seat belt.

To change reline position, see “Recline Position Adjustment” section.

Infant insert:

a. To install or remove infant insert, see “Infant Insert” section.
b. Discontinue use of infant insert when shoulder belts become too short to fit child.