Amana MEW5530 사용자 설명서

4. Install the 3/16" screw, and leave 1/8" (3.2 mm) to 3/16" 

(4.7 mm) protruding from the cutout floor.

5. Slide microwave oven partway into cutout opening.

6. Plug in microwave oven.
7. Make sure microwave oven is centered in the opening, and 

slide it into place, engaging the 3/16" screw and duct base.

1. Align bottom bracket to duct base, and mark 7 mounting 

holes of bottom bracket, as shown.

2. Using 7/64" drill, drill pilot holes into the cabinet through holes 

marked in Step 1.

3. Install bottom bracket to cabinet using seven 9/16" screws.
4. Position Template 2 over cabinet so that its reference holes (A) 

(for 27" [68.6 cm] installation) or (B) (for 30" [76.2 cm] 
installation) are over the upper end mounting holes of the 
bottom bracket, as shown in following illustration. Tape the 
template in place, then mark through holes (D) for 27" 
(68.6 cm) installation, or through holes (C) for 30" (76.2 cm) 
installation.

NOTE: If Template 2 is missing or unusable, measure straight 
up from upper end holes on bottom bracket, and mark the 
new holes at 12

¹⁵⁄₁₆" (32.9 cm) and 15²¹⁄₃₂" (39.8 cm). Make 

sure the bottom bracket end holes and the new holes on each 
side are plumb. 

5. Using 7/64" drill, drill pilot holes into the cabinet through holes 

marked in Step 4, then remove template. 

6. Position top bracket over pilot holes drilled in Step 5, then 

secure with four 9/16" screws. (Illustration in this step shows 
30" [76.2 cm] installation.) 

1. Position trim kit frame against the top and bottom brackets. 

Make sure the trim kit frame makes contact with the cabinet.

2. Open microwave oven door, and secure trim kit frame using 

4 painted 1/2" screws.

Installation is now complete. Replace any loose items that have 
been removed from microwave oven cavity.
Save these Installation Instructions for future reference.

A

B

B A

A B

C D

D C

C D

D C

A

B

C

D

A

B

C

© 2010

All rights reserved.

DE68-03169C

4/10

Printed in Malaysia