Vermont Casting MSY-D30NA 사용자 설명서

10

 

A maximum of 4 indoor units with wireless remote controllers can be used in a room.

 

In this case, to operate each indoor unit individually by each remote controller, P.C. boards of remote controller must be 
modified according to the number of the indoor unit.

For service, set time can be shortened by short circuit of JPG and JPS the indoor electronic control P.C. board. 
The time will be shortened as follows. (Refer to 9-7.)
Set time : 1-minute   1-second
Set time : 3-minute   3-second (It takes 3 minutes for the compressor to start operation. However, the starting time is 

shortened by short circuit-of JPG and JPS.)

How to set the remote controller exclusively for particular indoor unit
After you turn the breaker ON, the first remote controller that sends the signal to the indoor unit will be regarded as the remote 
controller for the indoor unit.
The indoor unit will only accept the signal from the remote controller that has been assigned to the indoor unit once they are 
set.
The setting will be cancelled if the breaker has turned off, or the power supply has shut down.
Please conduct the above setting once again after the power has restored.

Remove batteries before modification.
The board has a print as shown below :

The P.C. board has the print “J1” and “J2”. Solder “J1” and “J2” according to the number of indoor unit as shown in Table 1. 
After modification, press the RESET button.

 : For modification, take out 

the batteries and press 
the OPERATE/STOP (ON/
OFF) button twice or 3 
times at first.

 

After finish modification, 
put back the batteries then 
press the RESET button.

1 unit operation

2 units operation

3 units operation

4 units operation

No. 1 unit

No modifi cation

Same as at left

Same as at left

Same as at left

No. 2 unit

—

Solder J1

Same as at left

Same as at left

No. 3 unit

—

—

Solder J2

Same as at left

No. 4 unit

—

—

—

Solder both J1 and J2