Epson eh-tw3200 사용자 설명서

Setting up

* When suspending the projector from a ceiling, 

change the configuration menu settings.       p.34

* If you place the projector off to the side, aim it 

straight ahead (rather than at the center of the 
screen), then use the  horizontal lens shift dial 
to center the image on the screen.

Settings

Projection

Front
Front/Ceiling

TIP

You can rotate the EPSON logo plate around 180 degrees when suspending 
the projector from a ceiling.

When one end of the plate is pressed, the 
opposite end lifts up, so you can pull it out 
slightly, turn it around and then push it back in.

If you are installing the projector on the ceiling, this projector should be installed by 
qualified technicians using only approved mounting equipment. If installation work 
is not carried out correctly, the projector could fall down. This may result in injury or 
accidents. Contact your dealer to carry out the installation work.

If you use a ceiling mount and apply adhesives to the mount to prevent the screws 
from loosening, or if you use lubricants or oils on the projector, the projector 
housing may crack and the projector may fall from its ceiling mount. This could 
cause serious injury to anyone under the mount and could damage the projector. 
When installing or adjusting a ceiling mount, do not use adhesives to prevent the 
screws from loosening and do not use oils or lubricants.

Do not use the projector in places where there is a lot of humidity or dust, near cooking 
or heating appliances, or in places where it may come into contact with smoke or steam. 
Do not use or store this projector outdoors for an extended length of time. Fire or electric 
shock may result.

Clean the air filter at least once every 3 months.
Clean the air filter more frequently if using the projector in a dusty environment.

Do not use the projector on its side. This may cause malfunctions to occur.