Epson eh-tw3200 사용자 설명서

Maintenance

Press the knobs to release the catches, 
and then pull the cover upward.

Press       or 
          to turn 
off the power, 
and then turn 
the main 
power switch 
OFF.

Remove the air filter 
cover.

Dispose of used air filters properly 
in accordance with your local 
regulations. 
Frame material: PP
Filter materials: PP, PET

Do not touch the lamp cover soon after 
power-off or you may get burned because 
it is very hot.

TIP

* Wait until the lamp 

cools down (takes 
approximately 1 hour).

Insert the supplied screwdriver 
of  the replacement lamp into 
the lamp cover opening switch, 
then remove the lamp cover.

Securely tighten the 
lamp fixing screws.

Install the lamp cover.

Press       or           to 
turn off the power, and 
then turn the main power 
switch OFF.

Wait until the lamp has cooled 
down sufficiently before 
removing the lamp cover. If 
the lamp is very hot, you may 
get burned.

If the lamp stops working 
and needs to be replaced, 
there is the danger that the 
lamp may already be broken.
If replacing the lamp of a 
projector which has been 
installed to the ceiling, you 
should always assume that 
the lamp is broken and 
handle it with extreme care 
during removal. Furthermore, 
you should stand to the side 
of the projector, not 
underneath it.

Press       to turn on 
the power.

Press              to display 
the configuration menu.

The lamp operating time 
must always be reset after 
the lamp has been replaced 
with a new one.
The projector has a built-in 
counter which keeps track 
of the lamp operating time. 
When the cumulative 
operating time reaches a 
certain point, it causes the 
replacement warning 
message to be displayed.